60 °or 55° V-shaped and cone-shaped anvils (interchangeable) are optional.
Dimensions of anvil-tail:ø5x15mm.
Supplied with a standard caliper gage for zero setting.
The combining of extension rods provides a wide measuring range.
Supplied with a standard
caliper gage for zero setting.
Carbide measuring faces.
Diameter of extension rods:ø15.5mm.
The combining of extension rods provides a wide measuring range.
Carbide measuring faces.
Supplied with a standard caliper gage for zero setting.
Diameter of extension rods:ø22mm.
5-30mm/0.2-1.2"s、25-50mm/1-2" Micrometers furnished with setting ring.
For measuring various inside dimensions.
5-30mm/0.2-1.2"、25-50mm/1-2" Micrometers furnished with setting ring.
For measuring various inside dimensions.
For all kinds of inside measurement.
Large measuring range with two sides of calipers.
Bidirectional graduation for easy reading in both directions.
Supplied with setting ring ( ø30mm/1.2").
Range 2-6mm without extension rods.
Measurement can be taken closer to the bottom of the blind bore, and can be taken into a deep hole with an extension rod.
Highly durable because of carbide-tipped contact points.
Ratchet stop.
Titanium-plated anvils.
Over 100mm/4": Setting rings optional.
Over 100mm/4": Measuring heads are interchangeable.
Ratchet stop.
Aluminium body.
Three-point Internal Micrometers Sets.
Range 2-6mm without extension rods.
Measurement can be taken closer to the bottom of the blind bore, and can be taken into a deep hole with an extension rod.
Highly durable because of carbide-tipped contact points.
Ratchet stop.
